Veritas 5.0.1 Installation Guide HP-UX 11i v3 (5900-2464, September 2012)

The vxfsconvert command works with unmounted file systems. To upgrade mounted file
system, use the vxupgrade command, as described in step 8. You must run fsck after
vxfsconvert because vxfsconvert does not create all metadata files.
7. To run the VxFS-specific full fsck on the converted file system, enter the following command:
# fsck -F vxfs -y -o full <vol_name>
During pass 4, fsck displays several error messages that require a yes response to complete
the conversion process.
8. VxFS file systems with disk layout 4 can still be mounted with VxFS 5.0.1. However, to upgrade
to disk layout versions 5, 6, or 7, use vxupgrade, as follows:
a. To upgrade a mounted VxFS file system from disk layout 4 to disk layout 5, enter the
following command:
# vxupgrade -n 5 <mount_point>
b. To upgrade a mounted VxFS file system from disk layout 4 to disk layout 6, enter the
following command:
# vxupgrade -n 5 <mount_point>
# vxupgrade -n 6 <mount_point>
c. To upgrade a mounted VxFS file system from disk layout 4 to disk layout 7, enter the
following commands:
# vxupgrade -n 5 <mount_point>
# vxupgrade -n 6 <mount_point>
# vxupgrade -n 7 <mount_point>
9. To verify the conversion, enter the following command:
# fstyp -v <vol_name>
Upgrading from VxFS 3.5 on HP-UX 11i v2 to VxFS 5.0.1 on HP-UX 11i
v3
To upgrade from VxFS 3.5 on HP-UX 11i v2 to VxFS 5.0.1 on HP-UX 11i v3, complete the following
steps:
1. To determine the volume names, enter the following command:
# bdf
2. To determine the current disk layout version for system partitions, enter the following command:
# fstyp -v <vol_name>
3. To upgrade file systems with DLV 2 or 3, before installing 5.0.1, complete the following steps:
NOTE: You cannot upgrade from DLV 2 to DLV 4 directly. DLV4 is the lowest disk layout
that is supported by VxFS 5.0.1.
a. To upgrade a mounted VxFS file system from DLV 2 to DLV 3, enter the following
command:
# vxupgrade -n 3 <dir_name>
b. To upgrade a mounted VxFS file system from DLV 3 to DLV 4, enter the following
command:
# vxupgrade -n 4 <dir_name>
4. Upgrade to HP-UX 11i v3. For more information on upgrading, see the HP-UX 11i v3 Installation
and Update Guide at: http://docs.hp.com.
5. Install VxFS 5.0.1. For more information on installing VxFS 5.0.1, see Chapter 3 (page 26).
Upgrading from VxFS 3.5 on HP-UX 11i v2 to VxFS 5.0.1 on HP-UX 11i v3 47