Veritas 5.0.1 Installation Guide, HP-UX 11i v3, First Edition, November 2009

You can use one of the following methods to install the Veritas 5.0.1 products:
• Install the Veritas 5.0.1 products on an already existing HP-UX 11i v3 March 2009 OEUR or
later release
If you want to use this method, complete the instructions discussed in the following sections
to install Veritas 5.0.1 products:
— “Installing VxFS 5.0.1” (page 30)
— “Installing VxVM 5.0.1” (page 32)
— “Installing Storage Management For Oracle (SMO)” (page 33)
— “Installing CVM [B9117DB] on HP-UX 11i v3” (page 34)
• Cold-Install Veritas 5.0.1 products with HP-UX 11i v3.
If you want to use this method, see “Cold-Installing VxVM 5.0.1 and VxFS 5.0.1 with HP-UX
11i v3” (page 34) for the procedure to install Veritas 5.0.1 products.
• Update the HP-UX operating system to the HP–UX 11i v3 September 2009 OEUR or later
release and Veritas 5.0.1.
If you want to use this method, see “Updating HP-UX and Veritas Products Using the
update-ux Command” (page 36) for the procedure to install Veritas 5.0.1 products.
Installing VxFS 5.0.1
VxFS 5.0.1 consists of the Base-VxFS-501 and HP OnlineJFS (B3929GB) bundles. The following
sections discuss the installation of these bundles using the HP-UX Software Distributor (SD)
commands.
NOTE: You cannot install the Base-VxFS and the Base-VxVM 5.0.1 products on a system where
the Veritas 4.1 versions (for HP-UX 11i v2) of Storage Management for Oracle, HP Serviceguard
Storage Management, or HP Serviceguard Cluster File System product suites are installed. The
AVXFS and AVXVM products (included in VxFS 5.0.1 and VxVM 5.0.1, respectively) check the
installed products and the cause for an installation failure for the Veritas 5.0.1 products on such
systems. This issue is applicable only for systems that have been upgraded from HP-UX 11i v2
to HP-UX 11i v3.
Tools such as AVXFS, AVXVM, AVXTOOLS, AFULLVXVM, and AONLINEJFS help pull in
dependant products. For example, when you select VxVM 5.0.1, these tools automatically pull
in VxFS 5.0.1. These products also address issues of mutual exclusions.
Installing Base-VxFS-501
You can install Base-VxFS-501 either in the non-interactive mode or in the interactive mode.
Installing Base-VxFS-501 in Non-Interactive Mode
Enter the swinstall command in the non-interactive mode, as follows:
# swinstall -x autoreboot=true -s <depot-path> Base-VxFS-501
For more information on the supported options, see swinstall (1M).
30 Installing the Veritas 5.0.1 Products