Veritas File System 5.1 SP1 Administrator"s Guide (5900-1499, April 2011)

Table B-2
Unique message identifiers and messages (continued)
Message and DefinitionMessage Number
UX:vxfs command: ERROR: V-3-21268: message
■ Description
This message is printed by two different commands:
fsckpt_restore and mount. In both cases, the kernel's attempt
to mount the file system failed because of I/O errors or corruption
of the VxFS metadata.
■ Action
Check the console log for I/O errors and fix any problems reported
there. Run a full fsck.
21268
UX:vxfs command: ERROR: V-3-21272: message
■ Description
The mount options specified contain mutually-exclusive options,
or in the case of a remount, the new mount options differed from
the existing mount options in a way that is not allowed to change
in a remount.
■ Action
Change the requested mount options so that they are all mutually
compatible and retry the mount.
21272
UX:vxfs command: ERROR: V-3-23729: message
■ Description
Cluster mounts require the vxfsckd daemon to be running, which
is controlled by Veritas Cluster Server (VCS).
■ Action
Check the VCS status to see why this service is not running. After
starting the daemon via VCS, try the mount again.
23729
UX:vxfs command: ERROR: V-3-24996: message
■ Description
In some releases of VxFS, before the VxFS mount command
attempts to mount a file system, mount tries to read the VxFS
superblock to determine the disk layout version of the file system
being mounted so that mount can check if that disk layout version
is supported by the installed release of VxFS. If the attempt to read
the superblock fails for any reason, this message is displayed. This
message will usually be preceded by another error message that
gives more information as to why the superblock could not be read.
■ Action
The corrective action depends on the preceding error, if any.
24996
Diagnostic messages
Unique message identifiers
188