Veritas File System 5.1 SP1 Administrator"s Guide (5900-1499, April 2011)

Tuning VxFS I/O parameters
VxFS provides a set of tunable I/O parameters that control some of its behavior.
These I/O parameters are useful to help the file system adjust to striped or RAID-5
volumes that could yield performance superior to a single disk. Typically, data
streaming applications that access large files see the largest benefit from tuning
the file system.
Veritas Volume Manager queries
Veritas Volume Manager (VxVM) receives the following queries during
configuration:
■ The file system queries VxVM to determine the geometry of the underlying
volume and automatically sets the I/O parameters.
Note: When using file systems in multiple volume sets, VxFS sets the VxFS
tunables based on the geometry of the first component volume (volume 0) in
the volume set.
■ The mount command queries VxVM when the file system is mounted and
downloads the I/O parameters.
If the default parameters are not acceptable or the file system is being used without
VxVM, then the /etc/vx/tunefstab file can be used to set values for I/O
parameters. The mount command reads the /etc/vx/tunefstab file and downloads
any parameters specified for a file system. The tunefstab file overrides any values
obtained from VxVM. While the file system is mounted, any I/O parameters can
be changed using the vxtunefs command which can have tunables specified on
the command line or can read them from the /etc/vx/tunefstab file.
See the vxtunefs(1M) and tunefstab(4) manual pages.
The vxtunefs command can be used to print the current values of the I/O
parameters.
To print the values, type the following command:
# vxtunefs -p /mnt1
The following is an example tunefstab file:
/dev/vx/dsk/userdg/netbackup
read_pref_io=128k,write_pref_io=128k,read_nstream=4,write_nstream=4
/dev/vx/dsk/userdg/metasave
read_pref_io=128k,write_pref_io=128k,read_nstream=4,write_nstream=4
53VxFS performance: creating, mounting, and tuning file systems
Tuning I/O