Veritas Storage Foundation 5.1 SP1 for Oracle RAC Administrator"s Guide (5900-1512, April 2011)
The vxdctl -c mode command indicates whether a node is a CVM master or CVM
slave.
Verifying the state of CVM shared disk groups
You can use the following command to list the shared disk groups currently
imported in the SF Oracle RAC cluster:
# vxdg list |grep shared
orabinvol_dg enabled,shared 1052685125.1485.csha3
Verifying the activation mode
In an SF Oracle RAC cluster, the activation of shared disk group should be set to
“shared-write” on each of the cluster nodes.
To verify whether the “shared-write”activation is set:
# vxdg list dg_name |grep activation
local-activation: shared-write
If "shared-write" activation is not set, run the following command:
# vxdg -g dg_name set activation=sw
Administering SF Oracle RAC global clusters
This section provides instructions for the following global cluster administration
tasks:
■ About setting up a fire drill
See “Setting up a disaster recovery fire drill” on page 157.
■ Configuring the fire drill service group using the wizard
See “Configuring the fire drill service group using the Fire Drill Setup wizard”
on page 157.
■ Verifying a successful fire drill
See “Verifying a successful fire drill” on page 159.
■ Scheduling a fire drill
See “Scheduling a fire drill” on page 160.
For a sample fire drill service group configuration:
See “Sample fire drill service group configuration” on page 160.
Administering SF Oracle RAC and its components
Administering SF Oracle RAC global clusters
156