Veritas Storage Foundation 5.1 SP1 for Oracle RAC Administrator"s Guide (5900-1512, April 2011)

command on all the nodes in the cluster to change the values of the parameters.
To set an LLT parameter across system reboots, you must include the parameter
definition in the /etc/llttab file. Default values of the parameters are taken if
nothing is specified in /etc/llttab. The parameters values specified in the /etc/llttab
file come into effect at LLT start-time only. Symantec recommends that you specify
the same definition of the tunable parameters in the /etc/llttab file of each
node.
To set a timer tunable:
■ To set a timer tunable parameter using the lltconfig command:
# lltconfig -T timer tunable:value
■ To set a timer tunable parameter in the /etc/llttab file:
set-timer timer tunable:value
To set a flow control tunable
■ To set a flow control tunable parameter using the lltconfig command:
# lltconfig -F flowcontrol tunable:value
■ To set a flow control tunable parameter in the /etc/llttab file:
set-flow flowcontrol tunable:value
See the lltconfig(1M) and llttab(1M) manual pages.
About LLT timer tunable parameters
Table 5-3 lists the LLT timer tunable parameters. The timer values are set in .01
sec units. lltconfig –T query can be used to display current timer values.
Tunable parameters
About LLT tunable parameters
252