Veritas Storage Foundation™ for Oracle 5.0.1 Administrator's Guide

Snapplan parameters
When using dbed_vmchecksnap -o setdefaults option to create the snapplan,
the following parameters are set:
Table A-4
Snapplan parameters
ValueParameter
Specifies the snapshot version for this release of
Veritas Storage Foundation for Oracle
SNAPSHOT_VERSION
Specifies the name of the host where the primary
database resides.
In Oracle RAC, PRIMARY_HOST specifies the host
name of the CVM master node.
PRIMARY_HOST
Specifies the name of the host where the clone
database will reside.
In a Veritas Storage Foundation for Oracle
environment, if the primary and secondary hosts are
the same, the snapshot volumes will not be deported.
In Oracle RAC, SECONDARY_HOST specifies the host
name of the CVM master node in a single host
environment and the host name of the CVM slave
node in an offhost environment.
SECONDARY_HOST
Specifies the name of the Volume Manager disk group
used by the primary database.
PRIMARY_DG
The prefix to be attached to the primary disk groups
to create corresponding snapshot disk groups.
Snapshot disk groups will take the name using a
combination of SNAPSHOT_DG_PREFIX and the
corresponding primary disk group name. It's default
value will be SNAP_
SNAPSHOT_DG_PREFIX
The name of the Oracle database.ORACLE_SID
Veritas Storage Foundation for Oracle Command Line Interface
About the command line interface
348