Veritas Volume Manager 5.0.1 Administrator's Guide, HP-UX 11i v3, First Edition, November 2009

Lists the default values used by the rule’s attributes.check
Describes what the rule does.info
Lists the attributes of the rule that you can set.list
Runs the rule.run
See “Rule definitions and attributes” on page 515.
Discovering what a rule does
To obtain details about what a rule does, use the info keyword, as in the following
example:
# vxse_stripes2 info
VxVM vxse:vxse_stripes2 INFO V-5-1-6153 This rule checks for
stripe volumes which have too many or too few columns
Displaying rule attributes and their default values
To see the attributes that are available for a given rule, use the list keyword. In
the following example, the single attribute, mirror_threshold, is shown for the
rule vxse_drl1:
# vxse_drl1 list
VxVM vxse:vxse_drl1 INFO V-5-1-6004
vxse_drl1 - TUNEABLES default values
----------------------------------------------------------
mirror_threshold - large mirror threshold size
Warn if a mirror is of greater
than this size and does not have
an attached DRL log.
To see the default values of a specified rule’s attributes, use the check keyword
as shown here:
# vxse_stripes2 check
vxse_stripes2 - TUNEABLES
----------------------------------------------------------
VxVM vxse:vxse_stripes2 INFO V-5-1-5546
507Using Storage Expert
Running Storage Expert