Veritas Volume Manager 5.0.1 Administrator's Guide, HP-UX 11i v3, First Edition, November 2009

7
To verify that the array is recognized, use the vxdmpadm listenclosure
command as shown in the following sample output for the example array:
# vxdmpadm listenclosure
ENCLR_NAME ENCLR_TYPE ENCLR_SNO STATUS
======================================================
OTHER_DISKS OTHER_DISKS OTHER_DISKS CONNECTED
Disk Disk DISKS CONNECTED
The enclosure name and type for the array are both shown as being set to
Disk. You can use the vxdisk list command to display the disks in the array:
# vxdisk list
DEVICE TYPE DISK GROUP STATUS
Disk_0 auto:none - - online invalid
Disk_1 auto:none - - online invalid
...
8
To verify that the DMP paths are recognized, use the vxdmpadm getdmpnode
command as shown in the following sample output for the example array:
# vxdmpadm getdmpnode enclosure=Disk
NAME STATE ENCLR-TYPE PATHS ENBL DSBL ENCLR-NAME
=====================================================
Disk_0 ENABLED Disk 2 2 0 Disk
Disk_1 ENABLED Disk 2 2 0 Disk
...
This shows that there are two paths to the disks in the array.
For more information, enter the command vxddladm help addjbod.
See the vxddladm(1M) manual page.
See the vxdmpadm(1M) manual page.
Removing disks from the DISKS category
To remove disks from the DISKS category
◆
Use the vxddladm command with the rmjbod keyword. The following example
illustrates the command for removing disks supplied by the vendor, Seagate:
# vxddladm rmjbod vid=SEAGATE
95Administering disks
Discovering and configuring newly added disk devices