Veritas Volume Manager 5.1 SP1 Administrator"s Guide (5900-1506, April 2011)

the plex and then associate each of the subdisks with that plex. In this example,
the subdisks are associated to the plex in the order they are listed (after sd=). The
disk space defined as mydg02-01 is first, mydg02-00 is second, and mydg02-02 is
third. This method of associating subdisks is convenient during initial
configuration.
Subdisks can also be associated with a plex that already exists. To associate one
or more subdisks with an existing plex, use the following command:
# vxsd [-g diskgroup] assoc plex subdisk1 [subdisk2 subdisk3 ...]
For example, to associate subdisks named mydg02-01, mydg02-00, and mydg02-02
with a plex named home-1, use the following command:
# vxsd -g mydg assoc home-1 mydg02-01 mydg02-00 mydg02-01
If the plex is not empty, the new subdisks are added after any subdisks that are
already associated with the plex, unless the -l option is specified with the
command. The -l option associates subdisks at a specific offset within the plex.
The -l option is required if you previously created a sparse plex (that is, a plex
with portions of its address space that do not map to subdisks) for a particular
volume, and subsequently want to make the plex complete. To complete the plex,
create a subdisk of a size that fits the hole in the sparse plex exactly. Then,
associate the subdisk with the plex by specifying the offset of the beginning of
the hole in the plex, using the following command:
# vxsd [-g diskgroup] -l offset assoc sparse_plex exact_size_subdisk
For example, the following command would insert the subdisk, mydg15-01, in the
plex, vol10-01, starting at an offset of 4096 blocks:
# vxsd -g mydg -l 4096b assoc vol10-01 mydg15-01
Note: The subdisk must be exactly the right size. VxVM does not allow the space
defined for two subdisks to overlap within a plex.
For striped or RAID-5 plexes, use the following command to specify a column
number and column offset for the subdisk to be added:
# vxsd [-g diskgroup] -l column_#/offset assoc plex subdisk ...
If only one number is specified with the -l option for striped plexes, the number
is interpreted as a column number and the subdisk is associated at the end of the
column.
Creating and administering subdisks and plexes
Associating subdisks with plexes
276