HP WBEM Services for HP-UX System Administrator Guide (5900-1624, April 2011)

• Message: Failed to remove authorizations. Specified user authorizations
were not found.
Enter cimauth -l to list all the authorizations. Locate the one you want to remove and verify
that you have spelled it correctly. If it is not in the list, you need to add it with the -a option,
then re-issue the command.
• Message: CIM Server might not be running.
To see if cimserver is running, enter: ps -ef|grep cimserver
Perhaps an operator stopped it by command, but did not restart it. To start it.
HP-UX: cimserver (no options).
cimconfig command messages
• Message: Current value of properties cannot be listed because the CIM
Server is not running
Check for cimserver using ps -ef|grep cimserver. The server might not have started
during installation, or someone might have stopped it with cimserver -s for HP-UX. You
must restart the server by using the following:
HP-UX: cimserver (no options).
• Message: Failed to get property. Please make sure that the config
schema is loaded in the CIM Server.
Essential information is missing from the repository. For more information, see the “Maintaining
the repository” (page 31).
• Message: Failed to set the config property. Please make sure that the
config schema is loaded in the CIM Server.
Essential information is missing from the repository. For more information, see the “Maintaining
the repository” (page 31).
• Message: Failed to unset the config property. Please make sure that
the config schema is loaded in the CIM Server.
Essential information is missing from the repository. For more information, see the “Maintaining
the repository” (page 31).
• Message: Failed to list the config properties. Please make sure that
the config schema is loaded in the CIM Server.
Essential information is missing from the repository. For more information, see the “Maintaining
the repository” (page 31).
• Message: Specified property name was not found.
Check the spelling of the property name. Re-issue the command specifying a valid config
property. For a list of properties, enter: cimconfig -l
• Message: Specified property value is not valid.
See the cimconfig manpage for the range of allowed values for the property, and reissue
the command with a valid value.
• Message: Specified property cannot be modified.
You are trying to modify a property that is not dynamic. Dynamic properties can be changed
immediately, while CIM Server is running.
To modify a non-dynamic property you must modify the planned value, then stop and start
CIM Server (with cimserver command). For more information, see the cimconfig manpage.
48 Troubleshooting HP WBEM Services