HP Caliper for HP-UX Release Notes Release 5.5 (5900-2350, September 2012)

1 Highlights of This Release
NOTE: For the latest information about HP Caliper, see the HP Caliper Web site at http://hp.com/
go/caliper. In particular, you should go to the Latest Release page and see if there is any information
about problems found after the software kit was produced.
For more information about these highlights, see the HP Caliper User Guide.
If you have questions about HP Caliper, send email to [e-mail].
New Options and Enhancements in 5.5
The HP Caliper 5.5 release has the following improvements:
• Support for Intel® Itanium® 9500 processors is added.
• A new option --dcache-hits, is added. This option is available only on Intel® Itanium®
9500 processors. This option specifies that Caliper should measure and report dcache load
hits along with misses.
• A new option --dcache-stores, is added. This option is available only on Intel® Itanium®
9500 processors. This option specifies that Caliper should measure and report dcache store
misses.
• Enhancements to GUI: Support for obtaining "dcache hits" has been added in the Caliper
GUI. A check box has been provided for this purpose.
Deprecations
None
Deletions
None.
4 Highlights of This Release