HP-UX Directory Server Administrator Guide HP-UX Directory Server Version 8.1 (5900-3098, May 2013)

Table 42 Replication errors (continued)
RemedyImpactReasonError/symptom
Where 1d means 1 day.
Other valid time units are s
for seconds, m for minutes, h
for hours, and w for weeks. A
value of 0 turns off the purge.
With changelog purge turned
on, a purge thread that wakes
up every five minutes will
remove a change if its age is
greater than the value of
nsslapd-changelogmaxage
and if it has been replayed to
all the direct consumers of this
supplier (supplier or hub).
If it appears that the
changelog is not purged
when the purge threshold is
reached, check the maximum
time lag from the replication
monitor among all the
consumers. Irrespective of
what the purge threshold is,
no change will be purged
before it is replayed by all the
consumers.
Map the SSL port to a non-SSL
port in the configuration file
The SSL port is specified in
some replication agreement,
The Replication Monitor is
not responding. For
of the Replication Monitor.but the certificate databaseinformation on Replication
For example, if 636 is the SSLis not specified or notMonitor, see “Monitoring
port and 389 is the non-SSLaccessible by the Replicationreplication status” (page
383). port, add the following line in
the [connection] section:
*:636=389:*:password
Monitor. If there is no SSL
port problem, one of the
servers in the replication
topology might hang.
There is nothing wrong if
there is no change originated
from a supplier.
No change has originated
from the corresponding
suppliers. In this case, the
In the Replication Monitor,
some consumers show just
the header of the table. For
MaxCSN: in the header part
should be "None".
information on Replication
Monitor, see “Monitoring
replication status” (page
383).
390 Managing Replication