HP-UX IPv6 Transport Administrator's Guide for TOUR 2.0 (April 2004, rev 2)

Installation
Installing TOUR 2.0
Chapter 2 13
Installing TOUR 2.0
This section includes information on obtaining and installing TOUR 2.0.
It includes information needed before and after the TOUR 2.0
installation.
NOTE TOUR 2.0 is not compatible with some versions of IPSec. Before
installing TOUR 2.0, refer to the section titled “TOUR 2.0 and IPSec” on
page 15 of this guide.
Installation Instructions
To install TOUR 2.0, complete the following steps:
Step 1. Review “System Requirements” on page 11 to ensure your system meets
TOUR 2.0 requirements.
Step 2. Acquire the TOUR 2.0 software:
a. Go to the HP Software Depot at http://www.software.hp.com.
b. Search for “TOUR” and read the “Overview” and “Installation” pages
for TOUR 2.0.
c. Select Receive for Free >> option at the bottom right of the page.
d. Choose TOUR 2.0, software specification for the HP-UX 11i v2
release (“HP-UX 11.23 IA”.)
e. Enter your registration information, and read and accept the Terms
and Conditions statements.
f. Select Download at the bottom of the page and save the TOUR 2.0
release depot to a local file on your system, for example:
/tmp/TOUR.depot.
g. Use the swlist -d @ /tmp/TOUR.depot command to verify the
depot file is on your system.
Step 3. Use swinstall to install TOUR 2.0 from the location you saved the
depot file to. For example, run the following: