HP-UX IPv6 Transport Administrator's Guide for TOUR 2.0 (April 2004, rev 2)

Installation
Installing TOUR 2.0
Chapter 214
swinstall -x autoreboot=true -s /tmp/TOUR.depot TOUR
Notice that the target selection specified in the swinstall example is
“TOUR”, not “TOUR2”,since the TOUR 2.0 product bundle name is
“TOUR”. The product bundle version reflects the version change from 1.0
to 2.0.
The Mobile IPv6 product is optional. If you do not want to install Mobile
IPv6, use interactive swinstall and deselect the Mobile IPv6 product.
The system reboots automatically if the swinstall execution completes
without errors.
NOTE To minimize the number of required reboots, you may want to combine
patch requirements (patch depot files) and TOUR 2.0 software (depot
file) into one combined depot using the swcopy utility. Refer to the
swcopy(1M) man page for more information.
Additional Information
This section includes other relevant information about installing and
using TOUR 2.0.
Installation or Removal of Transport or PPP Patches
After installing TOUR 2.0, you cannot remove or install additional
transport patches. If you need to add or remove a transport patch, then
you will need to first remove TOUR 2.0. Separate patches for TOUR 2.0
(distinct from transport patches) will be available, as needed.
If you attempt to install a transport patch after installing TOUR 2.0, the
system displays the following message:
NOTE: The Transport Optional Upgrade Release (TOUR) is
already installed. HP-UX cumulative ARPA Transport patches
can NOT be installed because installing them would corrupt
TOUR. TOUR has a separate support mechanism (patches and new
versions). Please use this for updates to TOUR. If you must
install this patch PHNE_ nnnnn , then first remove TOUR.
If you attempt to remove a transport patch after installing TOUR 2.0,
the system displays the following message: