HP-UX IPv6 Transport Administrator's Guide for TOUR 2.0 (April 2004, rev 2)

Installation
Removing (Un-installing) TOUR 2.0
Chapter 2 17
Removing (Un-installing) TOUR 2.0
This section describes how to remove TOUR 2.0.
If you need to remove TOUR 2.0, be aware of the following:
• The save area under /usr/contrib/TOUR/save_area must be intact
(after installing TOUR 2.0, files in this directory must not be
removed).
• As part of removing TOUR 2.0, the base (default) HP-UX 11i v2
transport software is restored.
To remove (un-install) TOUR 2.0, do the following:
Step 1. Use the swremove command and specify the TOUR product. For
example,
swremove -x autoreboot=true TOUR
Step 2. Use the swlist command to verify the removal was successful. For
example,
swlist -l product TOUR
The TOUR product will no longer be listed.