HP-UX IPv6 Transport Administrator's Guide for TOUR 2.0 (April 2004, rev 2)

Troubleshooting
Diagnostic Flowcharts
Chapter 4 45
Flowchart 5 Procedures
A. Is error message “No such interface name”? If not, go to F. If so, the interface
name passed to ifconfig does not exist on the system. Using lanscan,
verify the spelling and names of the interfaces on the system.
If the system contains more than one LAN card, make sure the correct
number of LAN cards was configured into the kernel and that an ifconfig
command was executed for each interface.
B. Execute: lanscan. Execute lanscan to display information about the LAN
cards in your system.
C. Was correct interface name used? Configure interface using ifconfig with
the correct interface name. After reconfiguring using the correct interface
name, start again with Flowchart 4.
D. Is Hardware State UP? Verify the state of the hardware with the output
from the lanscan command. If the Hardware State is UP call your HP
representative for help, otherwise continue to E.
E. Execute: lanadmin.e lanadmin command to reset the LAN card. Go to
Flowchart 4.
F. Any other error message. Interpret any other error message and take the
appropriate action. Then repeat flowchart 4. If you receive the same error
message again, call your HP representative for help.