HP-UX iSCSI Software Initiator (iSCSI-00) B.11.31.03d Release Notes (February 2013)

ManualsBrandsHP ManualsSoftwareHP-UX iSCSI (SCSI Over TCP/IP) Software

HP-UX iSCSI Software Initiator (iSCSI-00)

B.11.31.03d Release Notes

HP-UX 11i v3

Abstract

This document contains specific information that is intended for users of this HP product.

HP Part Number: 5900-2349

Published: February 2013

Edition: 1

Summary of content (5 pages)

PAGE 1
HP-UX iSCSI Software Initiator (iSCSI-00) B.11.31.03d Release Notes HP-UX 11i v3 Abstract This document contains specific information that is intended for users of this HP product.
PAGE 2
© Copyright 2013 Hewlett-Packard Development Company, L.P. Legal Notices Hewlett-Packard makes no warranty of any kind with regard to this document, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be held liable for errors contained herein or direct, indirect, special, incidental or consequential damages in connection with the furnishing, performance, or use of this material. Confidential computer software.
PAGE 3
1 HP-UX iSCSI Software Initiator (iSCSI-00) overview The HP-UX iSCSI Software Initiator (iSCSI-00) is a software driver that allows HP-UX to access SCSI mass storage devices, using TCP/IP on Ethernet networks. iSCSI is an abbreviation of Internet Small Computer System Interface. The HP-UX iSCSI Software Initiator is a software implementation of the iSCSI protocol (RFC 3720) based on the HP-UX host TCP/IP stack.
PAGE 4
Corrective action: If a LUN is reported as NO_HW, this is a transient condition which will be stabilized with another ioscan command. To see the correct status, run ioscan again. • iSCSI Software Initiator events are not displayed. Event Monitoring Services (EMS) and Support Tool Manager (STM) do not display events generated by HP-UX iSCSI Software Initiator. Corrective action: None. This issue might be corrected in a subsequent release.
PAGE 5
Compatibility and installation requirements 5.1 Required patches None. 5.2 Operating system and version compatibility This release is specific for HP-UX 11i v3. 5.3 Hardware requirements This version of HP-UX iSCSI Software Initiator runs on HP Integrity and HP 9000 servers with the HP-UX 11i v3 operating system. Network interface cards (NICs) and network infrastructure components currently supported with HP-UX 11i v3 are required. NICs with 1 Gigabit or greater transfer rates are strongly recommended.