HP-UX iSCSI Software Initiator Support Guide, HP-UX 11i v1 and 11i v2, July 2005

Chapter 6
Troubleshooting
Troubleshooting Undetected Target Devices
66
reduced, or if there are unused bus instance entries, it may be necessary to change (compress) bus
instance assignments. This should only be done with the assistance of an HP support representative.
Contact HP support for further assistance.
8. When authentication is desired, if some targets are not seen due to authentication failure:
• Verify that the iradd daemon is running (if Bi-Directional CHAP authentication is desired).
• Verify that the configuration steps in “Challenge-Handshake Authentication Protocol (CHAP)
Configuration” on page 43, are followed.
9. When SLP based discovery is used and some targets are not seen in spite of the iSCSI islpd daemon
starting successfully (as per the /etc/rc.log and /var/adm/syslog/syslog.log files), please verify
the SLP configuration on the iSCSI target.