sasmgr.1m (2010 09)

s
sasmgr(1M) sasmgr(1M)
qualifier takes the enclosure and bay of the disk for which the firmware update is to be
done.
If the
-f option is not specified,
sasmgr displays a warning message before continuing
the command. Otherwise, it suppresses the warning message and continues executing
the command.
downloadfile
ctrl
Updates the firmware on the specified enclosure. The
downloadfile qualifier takes
the name of the file containing the new firmware. The
ctrl qualifier takes the enclo-
sure device file for which the firmware update is to be done.
If the
-f option is not specified,
sasmgr displays a warning message before continuing
the command. Otherwise, it suppresses the warning message and continues executing
the command.
downloadfile
hba
Updates the firmware on the specified HBA. The
downloadfile qualifier takes the
name of the file containing the new firmware.
If the
-f option is not specified, sasmgr displays a warning message before continuing
the command. Otherwise, it suppresses the warning message and continues executing
the command. This command requires superuser privileges. Refer to the Security Res-
trictions section below.
NOTE: If the firmware is being downgraded to a lower version, an incompatible older
version of the firmware may get rejected. This typically happens if the downgraded ver-
sion of firmware is very old compared to the current one on the card.
enable
Enables the SAS I/O card / HBA and brings it back online. This command causes the driver to
initialize the SAS I/O card / HBA.
get_info
When the get_info command is run without qualifiers, it returns information about the SAS
I/O card / HBA represented by device_file.
The following qualifiers are specified with the
get_info command:
lun Shows hardware path and SAS address information for a specific lun or all luns. If the
-N option and the -q lun=all qualifier are specified with this command, then it
displays persistent device file information.
lun_locate
Shows lun location information for the lun specified with the lun qualifier. If the
-N
option and the -q lun=all qualifier are specified with this command, then it displays
persistent device file information with the lun location information.
pci_id
Shows PCI ID information for the SAS I/O card / HBA.
phy Shows information about all PHYs or a specific PHY.
phy_in_port
Shows information about a port to which the specified PHY belongs or provides informa-
tion about all ports.
raid
Shows RAID configuration information for the Core I/O card / HBA. If the -N option is
specified with this command, then it displays persistent device file information.
reg Displays the contents of a specific PCI config space or MMIO register or all PCI config
spaces or MMIO registers. PCI config space or MMIO register type is specified with the
reg_type qualifier. If reg_type is not specified, then the command assumes a
default register type of MMIO.
smp Issues a SMP command. The file_name must contain the SMP request frame.
4 Hewlett-Packard Company − 4 − HP-UX 11i Version 3: September 2010