sd.5 (2011 03)

s
sd(5) sd(5)
swlist -a create_time -a create_date
Applies to swlist, swcopy, and swinstall
.
customer_id=
This number, printed on the Software Certificate, "unlocks" protected software and res-
tricts installation to a specific site or owner. You can enter the number with the
-x
customer_id= option or by using the Interactive User Interface. The customer_id can be
used on any HP-UX 10.X or later system.
Applies to
swinstall, swcopy, swlist.
defer_configure=false
Causes swinstall to automatically run configure scripts for the software_selections
after they are installed. (Alternate root directories are not configured.)
When set to true,
swinstall does not run configure scripts. If you want to configure
the software later, you must run the
swconfig command.
NOTES:
• Multiple versions of a product will not be automatically configured if another version
is already configured. Use the
swconfig
command to configure multiple versions
separately.
• SD ignores this option when it installs software that causes a system reboot.
Applies to
swinstall.
distribution_source_directory=/var/spool/sw
Defines the default location of the source depot (when the source_type is directory ).
You can also use the host :path syntax. The -s option overrides this default.
Applies to
swcopy, swinstall, and swpackage.
distribution_target_directory=/var/spool/sw
Defines the default distribution directory of the target depot. The target_selection
operand overrides this default.
Applies to
swacl, swcopy, swlist, swmodify, swpackage, swreg, swremove,
and swverify.
distribution_target_serial=/dev/rmt/0m
Defines the default location of the target tape device file. The target_selection operand
overrides this default.
Applies to
swpackage.
enforce_dependencies=true
Requires that all dependencies specified by the software_selections be resolved either in
the specified source, or at the target_selections themselves.
The
swconfig, swcopy, and swinstall commands will not proceed unless the
dependencies have also been selected or already exist at the target in the correct state
(INSTALLED, CONFIGURED, or AVAILABLE). This prevents unusable software from
being installed on the system. It also ensures that depots contain usable sets of software.
For
swremove, if a selected fileset has dependents (that is, other software depends on
the fileset) and they are not selected, do not remove the selected filesets.
If set to
false, dependencies are checked, but not enforced. Corequisite dependencies,
if not enforced, may keep the selected software from working properly. Prerequisite or
exrequisite dependencies, if not enforced, may cause the installation or configuration to
fail.
Applies to
swconfig, swcopy, swinstall, swremove, and swverify.
enforce_dsa=true
Prevents a command from proceeding past the analysis phase if the disk space required
is beyond the available free space of the impacted file systems. If set to false, then the
install, copy, or package operation will use the file systems’ minfree space and may fail
because it reaches the file system’s absolute limit.
14 Hewlett-Packard Company − 14 − HP-UX 11i Version 3: March 2011