swacl.1m (2012 03)

s
swacl(1M) swacl(1M)
controller appends the value to the value specified by the
admin_directory
option to
determine the path to the IPD. For alternate roots, this path is resolved relative to the
location of the alternate root. This option does not affect where software is installed, only
the IPD location.
This option permits the simultaneous installation and removal of multiple software appli-
cations by multiple users or multiple processes, with each application or group of applica-
tions using a different IPD.
Caution: use a specific
installed_software_catalog
to manage a specific applica-
tion. SD does not support multiple descriptions of the same application in multiple IPDs.
See also the
admin_directory
and run_as_superuser
options, which control
SD’s nonprivileged mode. (This mode is intended only for managing applications that are
specially designed and packaged. You cannot use this mode to manage the HP-UX
operating system or patches to it. For a full explanation of nonprivileged SD, see the
Software Distributor Administration Guide , available at the
http://docs.hp.com
web site.)
level= Defines the level of SD ACLS to view/modify. The supported levels are:
host, depot,
root, product, product_template
, global_soc_template
,or
global_product_template
.
See the discussion of the
-l option above for more information.
lookupcache_timeout_minutes=10
Controls the time in minutes to cache and re-use the results of hostname or IP address
resolution lookups. A value of 0 disables the facility to cache and re-use lookup results.
The maximum value allowed is 10080 minutes, which is one week.
A value of:
0 disables the lookup caching mechanism.
10080 is the maximum value allowed.
return_warning_exitcode=false
This option controls the exit code returned by SD’s controller commands. This option is
applicable only for a single target operation, and ignored when multiple targets are used.
When set to the default value of
false, swacl returns:
0 If there were no errors, with or without warnings.
1 If there were errors.
When set to
true, swacl returns :
0 If there were no warnings and no errors.
1 If there were errors.
2 If there were warnings but no errors.
rpc_binding_info=ncacn_ip_tcp:[2121] ncadg_ip_udp:[2121]
Defines the protocol sequence(s) and endpoint(s) on which the daemon listens and which
the other commands use to contact the daemon. If the connection fails for one protocol
sequence, the next is attempted. SD supports both the tcp (ncacn_ip_tcp:[2121])
and udp (ncadg_ip_udp:[2121]) protocol sequence on most platforms.
rpc_timeout=5
Relative length of the communications timeout. This is a value in the range from 0 to 9
and is interpreted by the DCE RPC. Higher values mean longer times; you may need a
higher value for a slow or busy network. Lower values will give faster recognition on
attempts to contact hosts that are not up, or are not running swagentd. Each value is
approximately twice as long as the preceding value. A value of 5 is about 30 seconds for
the ncadg_ip_udp protocol sequence. This option may not have any noticeable impact
when using the ncacn_ip_tcp protocol sequence.
run_as_superuser=true
This option controls SD’s nonprivileged mode. This option is ignored (treated as true)
when the invoking user is super-user.
HP-UX 11i Version 3: March 2012 − 5 − Hewlett-Packard Company 5