swlist.1m (2010 09)

ManualsBrandsHP ManualsSoftwareHP-UX Manpages

swlist(1M) swlist(1M)

return_warning_exitcode=false

This option controls the exit code returned by SD’s controller commands. This option is

applicable only for a single target operation, and ignored when multiple targets are used.

When set to the default value of

false

, swlist returns:

0 If there were no errors, with or without warnings.

1 If there were errors.

When set to

true, swlist returns :

0 If there were no warnings and no errors.

1 If there were errors.

2 If there were warnings but no errors.

rpc_binding_info=ncacn_ip_tcp:[2121] ncadg_ip_udp:[2121]

Deﬁnes the protocol sequence(s) and endpoint(s) on which the daemon listens and the

other commands contact the daemon. If the connection fails for one protocol sequence, the

next is attempted. SD supports both the tcp (

ncacn_ip_tcp:[2121]

) and udp

(

ncadg_ip_udp:[2121]

) protocol sequence on most platforms. See the sd(5) man

page by typing

man5sdfor more information.

rpc_timeout=5

Relative length of the communications timeout. This is a value in the range from 0 to 9

and is interpreted by the DCE RPC. Higher values mean longer times; you may need a

higher value for a slow or busy network. Lower values will give faster recognition on

attempts to contact hosts that are not up or not running

swagentd. Each value is

approximately twice as long as the preceding value. A value of 5 is about 30 seconds for

the ncadg_ip_udp protocol sequence. This option may not have any noticeable impact

when using the ncacn_ip_tcp protocol sequence.

run_as_superuser=true

This option controls SD’s nonprivileged mode. This option is ignored (treated as true)

when the invoking user is super-user.

When set to the default value of true, SD operations are performed normally, with per-

missions for operations either granted to a local super-user or set by SD ACLs. (See

swacl(1M) for details on ACLs.)

When set to false and the invoking user is local and is not super-user, nonprivileged

mode is invoked:

• Permissions for operations are based on the user’s ﬁle system permissions.

• SD ACLs are ignored.

• Files created by SD have the uid and gid of the invoking user, and the mode of created

ﬁles is set according to the invoking user’s umask.

SD’s nonprivileged mode is intended only for managing applications that are specially

designed and packaged. This mode cannot be used to manage the HP-UX operating sys-

tem or patches to it. For a full explanation of nonprivileged SD, see the Software Distri-

butor Administration Guide , available at the

http://www.hp.com/go/hpux-

core-docs web site.