swverify.1m (2011 03)

s
swverify(1M) swverify(1M)
If true, promotes the corequisite of a prerequisite to prerequisite. If
false
, core-
quisites are not used in determining load order.
logdetail=false[true]
Controls the amount of detail written to the logfile. When set to
true, this option adds
detailed task information (such as options specified, progress statements, and additional
summary information) to the logfile. This information is in addition to log information
controlled by the
loglevel option.
logfile=/var/adm/sw/swverify.log
Defines the default log file for each SD command. (The agent log files are always located
relative to the target depot or target root, for example,
/var/spool/sw/swagent.log
and /var/adm/sw/swagent.log
.)
loglevel=1
Controls the log level for the events logged to the command logfile, the target agent
logfile, and the source agent logfile. This information is in addition to the detail con-
trolled by the
logdetail option. See logdetail, above, and the sd(5) manual page
(by typing
man5sd) for more information. A value of:
0 provides no information to the logfile.
1 enables verbose logging to the logfiles.
2 enables very verbose logging to the logfiles.
log_msgid=0
Adds numeric identification numbers at the beginning of SD logfile messages:
0 (default) No identifiers are attached to messages.
1 Adds identifiers to ERROR messages only.
2 Adds identifiers to ERROR and WARNING messages.
3 Adds identifiers to ERROR, WARNING, and NOTE messages.
4 Adds identifiers to ERROR, WARNING, NOTE, and certain other informational mes-
sages.
lookupcache_timeout_minutes=10
Controls the time in minutes to cache and re-use the results of hostname or IP address
resolution lookups. A value of 0 disables the facility to cache and re-use lookup results.
The maximum value allowed is 10080 minutes, which is one week.
A value of:
0 disables the lookup caching mechanism.
10080 is the maximum value allowed.
mount_all_filesystems=true
By default, the SD commands attempt to mount all filesystems in the /etc/fstab file
at the beginning of the analysis phase, to ensure that all listed filesystems are mounted
before proceeding. This policy helps to ensure that files are not loaded into a directory
that may be below a future mount point, and that the expected files are available for a
remove or verify operation.
If set to
false, the mount operation is not attempted, and no check of the current
mounts is performed.
return_warning_exitcode=false
This option controls the exit code returned by SD’s controller commands. This option is
applicable only for a single target operation, and ignored when multiple targets are used.
When set to the default value of
false, swverify returns:
0 If there were no errors, with or without warnings.
1 If there were errors.
When set to
true, swverify returns :
0 If there were no warnings and no errors.
1 If there were errors.
2 If there were warnings but no errors.
rpc_binding_info=ncacn_ip_tcp:[2121] ncadg_ip_udp:[2121]
Defines the protocol sequence(s) and endpoint(s) on which the daemon listens and which
HP-UX 11i Version 3: March 2011 − 7 − Hewlett-Packard Company 7