Administrator's and User's Guide for SFM HP-UX 11i v3 March 2012

When the SFM software installs, the Install window appears indicating that the SFM software
is installed successfully, as shown in the following figure:
9. Unmount the CD. To unmount, enter the following command at the HP-UX prompt:
# unmount /tmp/cdrom
10. To verify whether the SFM software is installed properly, enter the following command at the
HP-UX prompt:
# swlist | grep SysFaultMgmt
If the SFM software is installed properly, SysFaultMgmt and the version number of the SFM
software are displayed in the output. If the SFM software is not installed properly, you must
repeat the installation procedure. For more information, see “Verifying the installation”
(page 22).
Installing using the CLI
To install the SFM software using CLI, complete the following steps:
1. Log in to the system as a superuser.
2. Mount the CD to a location of your choice, as in the following example:
# mount /dev/dsk/c1t2d0 /tmp/cdrom
Installing the SFM software from the media 21