Administrator's and User's Guide for SFM HP-UX 11i v3 March 2012

3. For information about errors related to the removal of SFM, enter the following command at
the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the Logfile.
Verifying removal using the CLI
To verify if the SFM software is removed successfully, complete the following steps:
1. Log in to the system as a superuser.
2. Enter the following command at the HP-UX prompt:
# swjob
If the output contains no errors, the SFM software is removed successfully. If the SFM software
is not removed properly, you must repeat the removal procedure. See “Removing the SFM
software” (page 24) for instructions on how to remove the SFM software.
3. For information about errors related to the removal of the SFM software, enter the following
command at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the output of the swjob command.
28 Installing the SFM software