Administrator's and User's Guide for SFM HP-UX 11i v3 March 2012

The sfmconfig -a -r command is used to change the state of a subsystem. When this command
is not working with processor, the user should check for errors. When a CPU is deactivated on a
system due to an action taken against an error symptom, the user tries to use sfmconfig command
to make the CPU state back to OK The change does not happen unless the processor which is
faulty is replaced or it is acquitted from the Onboard Administrator on HP Superdome 2.
Viewing instances
To view information about processors, memory, cooling devices, power supplies, and disks,
complete the following steps:
1. On the System Page of HP SIM, click System Management Homepage, as shown in Figure
4–14.
Figure 15 System Page
The HP SMH home page is displayed.
2. Perform the relevant steps described in “Viewing instances” (page 44).
Viewing instances 43