ClusterPack V2.5 Release Note

QuickStart Install Instructions

• HP-UX 11iv2 TCOE

• HP-UX 11i Ignite-UX (B5725AA)

For HP-UX 11iv3

Install the following software on the Management Server.

• HP-UX 11iv3 TCOE

• HP-UX 11i Ignite-UX (IGNITE)

Install the following software on each Compute Node.

• HP-UX 11iv3 TCOE

• HP-UX 11i Ignite-UX (IGNITE)

Allow the default choices to install.

ClusterPack requires a homogeneous operating system environment. That is, all

Compute Nodes and the Management Server must have the same release of HP-UX

installed as well as the same operating environment.

The Management Server requires at least one LAN connection. The manager must

be able to contact all the Compute Nodes using a "management network" that will

be configured by ClusterPack. In addition, the management server must be able to

connect to all the MP cards on the Compute Nodes. No network connections need to

be configured before installing ClusterPack. The console interface can be used for

all installation and configuration steps.

The Compute Nodes must have Management Processor (MP) cards.

ClusterPack depends on certain open source software which is normally installed as

a part of the operating environment. The minimum release versions required are:

HP-UX 11iv2

• Perl Version 5.8 or higher

HP-UX 11iv3

• Perl Version 5.8 or higher

Step 3. Allocate File System Space

Allocate file system space on the Management Server. Minimum requirements are

listed below.