HP-UX SNAplus2 R7 11iv1 Release Notes (September 2005)

HP-UX SNAplus2 R7.11.11.001 Release Notes

Fixes in This Version

Chapter 1 13

8606106196 SNAplus2 R6.10.20 - Unable to add SDLC on T500 system - SAM core

dumps.

8606106251 SNAplus2 R5.1 API PHNE_14874 incorrectly refs

../../o/lib/libnof.sl.

8606106291 R6.11.00.201 NIO PSI panic at sdl_reset_port+0x13c with SDLC L2

tracing.

8606106415 SNAplus2 R6.10.20 System panic when starting SDLC Link with

PHNE_19407.

8606106417 R6.11.200 snap3270 error msg “Unable to open the conﬁguration ﬁle”.

8606107303 SNA SAM should not install sixw on machines with no PCI bus.

8606110474 R5 Snapadmin - deactive_session for 3270 is not supported in SNAplus2.

8606110538 Enhance Snaplus2 xsnap3270 so title changes are immediate.

8606110894 R5 snap3270 is stopped and restarted, then HA_CONNECT_PS returns

RC=9.

8606111714 R6.11.00 snamsgf fails with “Unable to open catalog ﬁle./vsnamsg.cat”.

8606111815 R6.1029 SID’s ABM bit error on starting a QLLC connection.

8606112613 R6 SNAplus2 CICS for HP-UX fails to run after installing

PHNE_17820/19071.

8606127677 SNAplus2 R6.11.00 - sdlc & link port remain in stopping state.

8606128040 R6.11.64 bit system panic in nba_mm_free/nlu_remove_mode.

8606128605 3270 LUs show inactive on HP system, while IBM system shows them as

active.

8606134781 SAM/ SNA: Cannot ﬁnd tunable parameter - num_boards_3525.

8606135068 SNAplus2 R6.11.00 reboot required to activate sdlc LS once deactivated.

8606144341 R6.11.00: SNAplus2 support needed on ACC SDLC PCI interface.

8606144657 R6,10.20: system panic in ncs_destroy_an_cv_if_required (libsixr.a).

Table 1-1 Software Fixes (Continued)

SR Number Problem