HP-UX SNAplus2 R7 Administration Guide
Configuring Dependent LUs
Defining LU Types 0–3
6 Configuring Dependent LUs
This chapter provides instructions for configuring LUs and LU pools to support user applications that use 3270,
TN3270, RJEand LUA communications. To use these, you must configure dependent LUs.
Before you can configure the resources described in this chapter, you must perform the following configuration:
• Configure the node as described in Section 4.2,
Configuring the Node.
• Configure connectivity as described in Chapter 5, Defining Connectivity Components. For 3270, TN3270,
RJEand LUA, you must configure the link to support dependent LU traffic.
You do not need to configure a direct link to the host if you are using upstream PU concentration or DLUR.
For more information, see Section 9.2, Configuring PU Concentration and Section 5.3, Defining DLUR PUs.
6.1 Defining LU Types 0–3
You must configure dependent LUs of types 0–3 to support communication with a host system. You can use the
information in this section to define an LU to support 3270, RJE or LUA. You can also define a range of LUs, to
configure multiple LUs of the same type in a single operation.
To configure an LU of types 0–3, use one of the following methods:
Motif administration program
Select one of the following from the
Services menu on the Node window.
•
3270 and either
New 3270 display LU
or
New 3270 printer LU
• RJE and New RJE LU
•
LUA and New LUA LU
• TN server
and New host LU
Command-line administration program
Issue one of the following commands:
define_lu_0_to_3
define_lu_0_to_3_range
You can use the advanced dialog to restrict access to a specific SSCP, or to specify an inactivity timeout.
Note
If you are configuring a 3270 display LU for use with the SNAplus2 3270 emulation
program, and users may use this LU for file transfer, the host configuration for this LU
must specify DFT mode (3279 configuration), and not CUT mode (screen mode). Although
there will be no difference when using the LU for 3270 emulation, SNAplus2 does not
support CUT mode file transfer. If an LU is configured at the host as CUT mode, any
attempts to transfer files on a session using this LU will fail.
Check the host logmode table entry for the LU with your host administrator. The query bit
in the PSERVIC operand of the MODEENT macro must be set to indicate a DFT mode
LU; this means that the third hexadecimal digit (upper digit of the second byte) of the
PSERVIC operand must be
8.
100