HP-UX SNAplus2 R7 Administration Guide

Administering SNAplus2

Using the Motif Administration Program

Figure 3–1 SNAplus2 Domain Window

If any active nodes in the domain (nodes on which SNAplus2 is running) are not conﬁgured, SNAplus2 prompts

you to conﬁgure the node.

Note

The Domain window does not list SNAplus2 clients. Clients use the resources of SNAplus2

servers (SNA nodes) to access SNA resources.

You can perform any of the following administration tasks from the Domain window:

Start or stop any node in the domain

Select the line for the node and click on the

Start or Stop button on this window. (Alternatively, you can click

on the line for the node, then select

Start node or Stop node from the Selection menu.)

Administer a speciﬁc node

Double-click on the line for that node on the Domain window. (Alternatively, you can click on the line for

the node, then select

Properties from the Selection menu. You can also select the window for the node from

the

Windows menu.)

When you select a node to be administered, SNAplus2 displays the Node window as shown in Figure 3–2,

Node Window. (For a standalone system, SNAplus2 does not display the Domain window, because the

domain has only one node. Instead, SNAplus2 immediately displays the Node window when you start the

administration program.)

Add a node to the list of servers for the domain

Click on the line for the node and select

Make conﬁguration server from the Selection menu.

Remove the node from the list of servers for the domain

Click on the line for the node and select

Remove conﬁguration server from the Selection menu.

Conﬁgure logging for all nodes in the domain