HP-UX SNAplus2 R7 Administration Guide
Defining Connectivity Components
Defining DLUR PUs
Whether SNAplus2 retries the attempt to contact the DLUS if it fails on the first attempt. If you set this
option, SNAplus2 will retry indefinitely if the first attempt fails. If you do not set this option, it will only
retry once.
5.3.2 Parameters for Passthrough DLUR for Downstream Nodes
You need the following information in order to configure SNAplus2 to use passthrough DLUR to transport traffic
between dependent LUs on downstream nodes and a host:
Downstream PU name
The PU name associated with the downstream node. The PU name must match the PU name configured on
the host computer.
A downstream node can support multiple PUs. In this case, each downstream PU is associated with a different
link, so you need to configure multiple links between the SNAplus2 DLUR node and the downstream node,
and you need to know the downstream PU name for each link.
Consult your SNA network planner to find out the PU names associated with the downstream nodes.
DLUS name
The fully qualified LU name of the host LU that supports the DLUS. In order to use DLUR, the DLUR
component of SNAplus2 has to establish an LU-LU session with the DLUS on the host.
Consult your SNA network planner to find out the LU name for the host DLUS server.
5.3.3 Additional Configuration
After configuring DLUR, continue with the following configuration tasks:
• To configure LUs for DLUR, see Section 9.3, Configuring DLUR.
• To configure other passthrough services, see Chapter 9, Configuring Passthrough Services.
• To support specific user applications, see Chapter 8, Configuring User Applications.
• To support APPC communication, see Chapter 7, Configuring APPC Communication.
99