HP-UX SNAplus2 R7 Upgrade Guide (September 2005)

Upgrading from Earlier Versions of SNAplus2 to R7
Upgrading a Complete Client/Server System in One Pass
Chapter 2 11
Upgrading a Complete Client/Server System
in One Pass
It is better to upgrade the complete client/server system in one pass
instead of a phased upgrade. To upgrade the system in one pass, follow
this procedure:
Step 1. Log in as root.
Step 2. Stop the SNAplus2 software on all servers and clients.
Step 3. Install the new version of the SNAplus2 software on all servers and
HP-UX clients. For each computer:
a. Run the swinstall utility to copy the software from the installation
media. swinstall will rebuild the kernel.
b. From the server or client computer, run SAM.
c. Double-click on the "Networking and Communications" icon.
d. Double-click on the "SNAplus2 Installation" icon. (SNAplus2
Installation may take a few minutes to come up.) Verify the
configuration, if the operating system has not been upgraded.
If the upgrade process includes an upgrade to the operating system,
SNAplus2 must be reconfigured. (Do this in SAM by double-clicking
the entry “SNAplus2 Environment”.)
For assistance, use the SNAplus2 installation online help.
e. Exit from SNAplus2 Installation.
Step 4. Start the new SNAplus2 software on the master server first, and then on
all remaining servers and HP-UX clients.