HP-UX SNAplus2 Release Notes (September 2008)(Version R7.11.11.300)

HP-UX SNAplus2 R7.11.11.300 Release Notes
Compatibility Information and Installation Requirements
Chapter 18
Running HP SNAplus2EE Link in a client/server environment requires additional LAN/9000
Link softwarecomponents for servers and workstations.
Running HP SNAplus2EE Link using QLLC requires X.25 (J2793A) software.
Running HP SNAplus2EE Link using Token Ring, 802.3/Ethernet, or FDDI requires software
for each link type.
Optional
Running xsnapadmin, the configuration and management GUI, requires the following
software:
• Motif interface software
• bit-mapped display to run X11
HP SNAplus2EE APPN End Node
The HP SNAplus2EE APPN End Node requires the same hardware and software as the HP
SNAplus2EE Link.
HP SNAplus2 APPN Enterprise Extender and NN
The HP SNAplus2 APPN Enterprise Extender and NN requires the same hardware and
software as the HP SNAplus2EE Link.
Installation Requirements
After you determine that you have the hardware and software required for the SNAplus2
products you are installing, you can begin loading the product files. Be sure to have a
CD-ROM drive attached to your system to read the product media. This drive must be
configured on your system with an entry in the /dev directory.
Use the /usr/sbin/swinstall program to load the product files into the appropriate
directories on your system. For specific instructions on using swinstall, refer to the HP
Software Distribution Utilities (SD) User’s Guide.
To add the SNAplus2 Environment and Link components, run the SAM SNAplus2
Installation Program on the SAM Networking and Communications screen.