HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjepur
Chapter 4 103
snaprjepur
The snaprjepur command purges status information for a job that has
been sent to the host. The job must be purged by the user who submitted
it (using the same user ID), except that a user logged on as root can
purge any job.
SNAplus2 stores information on sent jobs only if the list_sent_jobs
option is set in the workstation style file (see Chapter 6, “SNAplus2 RJE
Workstation Configuration,” of this manual for more information). If you
use this option, you should use the snaprjepur command regularly to
ensure that SNAplus2 does not retain too much information (which may
affect disk occupancy or the performance of RJE programs).
You must use this command on the computer for which the RJE
workstation is configured (unless your system administrator has set up
the configuration to allow spool commands to be issued from other
computers), and the SNAplus2 software must be started on that
computer. However, the RJE workstation need not be running. See your
system administrator if necessary, or refer to the HP-UX SNAplus2
Administration Guide for information on RJE workstation configuration
or on starting the SNAplus2 software.
Syntax
snaprjepur [ -r ] WKST spool-id [ spool-id .. ]
snaprjepur [ -r ] WKST ALL
Options
-r
Indicates Root. Normally you can purge information
for a job only if you submitted it (that is, if you are
logged on using the same user ID with which the job
was submitted); the snaprjepur command will not
purge information for a job that was submitted using a
different user ID. The -r option, which is valid only if
you are logged on as root, forces the information to be
purged regardless of the user ID with which the job
was submitted.
Parameters