HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjepur
Chapter 4104
WKST
The name of the RJE workstation to which the job was
submitted. This must be the name of an RJE
Workstation in the SNAplus2 configuration file,
whether or not the named workstation is currently
running. The workstation name is not case sensitive.
spool-id
The spool ID of the job for which information is to be
purged. You can purge information for more than one
job by specifying more than one spool ID.
To check the spool ID for a sent job, use the snaprjelst command (with
the -s option) to list the sent jobs for the workstation with their spool
IDs. The spool ID is similar to the spool ID returned to the snaprjesend
command when the job was submitted, except that the initial characters
SPL are replaced by STS when the job is successfully sent.
To purge information on all jobs submitted using your user ID (or all jobs
regardless of user ID if you are using the -r option), replace the list of
spool IDs by the word ALL or all.
Example
To purge information on a job sent to the host, type the following
command:
snaprjepur RJE1 STS_fjghld
When you use the command as in the above example, the program
responds with the following message:
Job STS_fjghld cleared
Other messages may be sent to standard error, indicating (for instance)
that a parameter in the workstation style file was invalid, or that an
invalid option or an invalid workstation name was supplied. In
particular, the -r option is treated as an invalid option if you are not
logged on as root.