HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjestat
Chapter 4 105
snaprjestat
The snaprjestat command is used to check the status of RJE
workstation devices and LUs. Before you can view the status, you must
have run the workstation at least once so that workstation directories
are present. Additional information about jobs submitted and data files
received can be obtained by looking at the audit log file. (See the section
“Getting Information About RJE Jobs”, earlier in this manual).
Syntax
snaprjestat [-d] [-l] WKST
Options
By default, snaprjestat displays both workstation device status and LU
status. The user can specify a list of workstation names, or this list can
be read from STDIN.
-d
When the -d option is used, snaprjestat reports on
workstation device status only.
-l
When the -l option is used, snaprjestat reports on
workstation LU status only.
Parameters
WKST The name of the workstation whose status information
will be displayed. This workstation must be an RJE
workstation in the current configuration file.
You may specify more than one RJE workstation here,
provided that you leave a space after each.
Alternatively, you may enter the snaprjestat
command and press Return. Then type the name of an
RJE workstation followed by Return to view its status.
You may continue to view the status of further
workstations by typing their names followed by Return.
When you have finished, press CTRL-D to exit the
command. You may also redirect STDIN to a file
containing workstation names.