HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjestat
Chapter 4108
Sending
The LU is being used by a device to
send a file or console command to the
host.
Suspended
The LU is currently suspended by the
host while receiving a file.
Idle
A session exists for the LU, but there
is currently no activity.
device
The device that is currently using this LU. For
disconnected, pending or idle LUs, device is indicated
as *.
The snaprjestat command will return the following exit codes:
-1
An error has occurred with the command.
0
The workstation is active and connected.
1
The workstation is active, but no LU is currently active
(all LUs are either disconnected or pending).
2
The workstation is inactive
The snaprjestat command always returns a value of 0 if more than one
workstation is specified and there is no command error.
Example
snaprjestat RJE1
If you enter the command above, your screen displays the status of
configured devices for workstation RJE1 and their current actions. It
also shows the status of configured LUs for RJE1. The following figure is
an example of the screen display. The RJE1 workstation has five