HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjeclr
Chapter 4112
snaprjeclr
The snaprjeclr command removes the files and directories associated
with an RJE workstation. The files and directories will be rebuilt if a
new job is submitted for the workstation, or if the workstation is
restarted.
The command must be issued by the system administrator. Note that
this command will remove all of the following:
• Jobs spooled for this workstation
• Status information stored for sent jobs
• Output files on the default output directory
• Console information
The command should only be used when the workstation is no longer
required, or to clean up after a serious error condition. Before using the
command, you must ensure that the workstation and the console
program are not running.
If the workstation’s main directory contains an RJE style file, this file is
copied into the main RJE directory /var/opt/sna/rje before the
workstation’s files and directories are deleted. If you are removing the
workstation from the configuration, you should delete this file. If you are
only clearing the directories and intend to continue using the
workstation, you should recreate the directory /var/opt/sna/rje/ WKST ,
where WKST is the name of the workstation, and move the style file into
this directory.
You must use the command on the computer for which the RJE
workstation is configured, and the SNAplus2 software must be started
on that computer. Refer to the HP-UX SNAplus2 Administration Guide
for information on RJE workstation configuration or on starting the
SNAplus2 software.
Syntax
snaprjeclr WKST
Parameters
WKST