HP-UX SNAplus2 RJE User's Guide

Getting Started
Using SNAplus2 RJE
Chapter 2 31
Wkst Device Status LU Name Action
------------------------------------------------------------
RJE1 CONS Inactive * *
RJE1 PUN4 Inactive * *
RJE1 PUN3 Inactive * *
RJE1 PUN2 Inactive * *
RJE1 PUN1 Inactive * *
RJE1 RDR1 Inactive * *
RJE1 PRT3 Inactive * *
RJE1 PRT2 Inactive * *
RJE1 PRT1 Inactive * *
Wkst LU Name Status Device
------------------------------------------------------------
RJE1 RJELU09 Idle *
RJE1 RJELU08 Idle *
RJE1 RJELU07 Idle *
RJE1 RJELU06 Idle *
It may take a minute for the workstation to establish a session with the
host. Continue checking on the workstation by reissuing the command
until you see that the status of the LUs are either Idle, Sending or
Receiving. If the LUs stay in the Pending state, check to see that the LUs
are active on the host side. See your host administrator if the problem
persists.
Using the Console Program
You can also check the status of the workstation with the RJE console
program. Type the following command:
snaprjecon RJE1
The status line for the console appears at the bottom of the screen and
shows the following:
F1 HELP INSERT RJE1+ FOLLOW
Pressing f1 displays console help information.
INSERT means the editor is in insert mode. Text typed at the command
line is inserted at the cursor position. REPLACE appears when the editor
is in replace mode. Text typed will overwrite existing text.
RJE1+ indicates that the workstation has established a session with the
host. RJE1- appears when the workstation has not established a session
with the host.