HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Components and Operation
Processing Output Data
Chapter 3 59
The default notify value is 77. If you do not specify a
notify value in the usr card, the default value of 77 will
be used.
Note that if you select notification to terminal, there are three
circumstances requiring some caution:
• If you are logged on to multiple terminals (or you are in multiple
windows), the messages go to the lowest tty value for your specified
user_id. This means that the notification message may come back to
a terminal other than the one from which you issued the
snaprjesend command.
• If you are running windows on your terminal and if the terminal (not
an individual window) is the lowest shell, the message goes to the
terminal rather than into a window.
• Messages will overwrite a graphical window display. To recover, you
must repaint the screen.
You must be logged onto the HP-UX system to receive notification
messages to your screen. If you are not logged on, SNAplus2 RJE will
discard screen messages.
Including the usr Card in Your File
To use the usr card successfully, apply the following rules:
• You must include a usr card in the first 22,000 bytes of data of each
received file from the SNA host computer in order to determine the
destination for that file.
Table 3-1 Notification Values
Notification Method When File is Received
Values Mail Terminal None
11, 21, 41, 71 * *
12, 22, 42, 72 *
14, 24, 44, 74 *
17, 27, 47, 77
(default is 77)
*