HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Components and Operation

Running the RJE Workstation

Chapter 3 67

Starting the Workstation

Before starting an RJE workstation , be sure that the SNAplus2 daemon

is running. See your system administrator if necessary, or refer to the

HP-UX SNAplus2 Administration Guide.

Also, be sure that your login ID is in the group conﬁgured for this

workstation.

To start the RJE workstation, use the following command:

snaprjestart

WKST

NOTE The workstation name (

WKST

) can be only four characters long and is

always in uppercase. If you enter it in lowercase, SNAplus2 RJE will

convert it to uppercase. For more information on this command, see

chapter 4 of this manual.

Normally, once the workstation starts, it will continue to run until you

stop it with the snaprjestop command (see the section “Stopping the

Workstation” later in this chapter). Alternatively, you can specify a

time-out parameter with the -sn option when starting the workstation.

In this case, the workstation stops when both of the following conditions

are true:

• All the spooled jobs have been sent to the host and the speciﬁed time

(in minutes) has elapsed with no RJE activity such as, no jobs

submitted, no console commands entered, and no output or console

messages received.

• The workstation has lost contact with the local node, and the

speciﬁed time (in minutes) has elapsed without reestablishing

contact. This generally occurs because the local node has been

stopped.

If you need to stop the workstation quickly without waiting for RJE

activity to end, use the snaprjestop command.

Displaying Workstation Status

To display a workstation’s status information, ensure that your login ID

is in the group conﬁgured for the workstation. See your system

administrator if necessary.