HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjestart
Chapter 4 81
snaprjestart
The snaprjestart command starts the RJE workstation which
performs the following tasks:
• Transfers jobs from the spool to the host for processing
• Receives output from the host and routes it to the appropriate file or
program.
• Provides access to host console information
Start the SNAplus2 RJE workstation on the computer for which it is
configured. The SNAplus2 software must also be started on that
computer. See your system administrator if necessary, or refer to the
HP-UX SNAplus2 Administration Guide for information on RJE
workstation configuration and starting the SNAplus2 software.
Syntax
snaprjestart [-s n ] WKST
Options
-sn
The -s n option, where n is a decimal number
(minimum 1), indicates that the workstation should
stop after n minutes with no RJE activity. In other
words, the workstation stops when there have been
none of the following for n minutes:
- Jobs on the spool waiting to be submitted
- RJE console commands
- Output returned from the host
- Console messages from the host
If this option is not used, the workstation continues to
run indefinitely, whether or not any work arrives. To
stop it, you must use the snaprjestop command.
Parameters
WKST