HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjestop
Chapter 4 83
snaprjestop
The snaprjestop command stops the RJE workstation.
You must use this command on the computer on which the workstation is
running (the computer for which it is configured). See your system
administrator if necessary, or refer to the HP-UX SNAplus2
Administration Guide for information on RJE workstation configuration.
Syntax
snaprjestop [-s n | -j | -i] WKST
Options
-sn
The -s n option is the “inactivity” option. It stops the
workstation after n minutes of inactivity. The
workstation continues to process any jobs waiting on
the spool. It stops when there have been none of the
following for n minutes (minimum 1):
- Jobs on the spool waiting to be submitted
- RJE console commands
- Output returned from the host
- Console messages from the host
-j
The -j option is the “finish job” option. If the
workstation is currently sending a job to the host,
and/or receiving data from the host, it finishes these
transactions. It then stops without processing further
jobs. Any unprocessed jobs remain on the spool and
may be sent during a later run of the workstation.
-i
The -i option is the “immediate” option. When you
use this option, the workstation stops immediately. Any
job currently being sent to the host, and any output
currently being received from the host is abandoned.
Use this option only in error conditions since it will