HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjesend
Chapter 4 87
Specifies the number of retry attempts for this job. If
an error occurs during the sending of this job, the
workstation will retry sending the job as many as n
times. The maximum value for n is 99. n must be
specified with this option. If -a n is not specified, the
number of retry attempts defaults to 10.
-z
Submits file for transmission without interpreting the
file. Any other options specified in this command that
require reading the file will be ignored. You must
include a file name when you specify this option. This is
the fastest way to queue a file, because the input is not
interpreted line by line. Only the -q option may be
used with this option. Any file that you queue with this
option will be translated ASCII to EBCDIC.
-m n
The -m n option indicates that the job file should be
sent in records of n bytes (in the range 80 - 248). If this
option is not used, the default record length is 80 bytes
for punch data (without the -e option), or 128 bytes for
exchange data (with the -e option). See “Sending
Exchange Data” in chapter 3.
-r [-s n ]
The -r option runs the RJE workstation if it is not
already running after submitting the job.
The -s n option is only valid if the -r option is also
specified. The combination of -r and -s n is equivalent
to the command snaprjestart -s n WKST , which
specifies that the workstation should start, complete all
outstanding jobs, and then time out after n minutes
with no RJE activity. See the section on the
“snaprjestart” command for more information.
Parameters
WKST