HP-UX Software Assistant Administration Guide (5900-3003, March 2013)

Verifying selected systems
After you select Apply from one of the selection methods listed above, the Verify Target Systems
page is displayed. Use the buttons at the bottom of the system list to manage your selections.
• Select Add Targets... and add systems to the target systems list as described in “Selecting
target systems” (page 27). Select Apply. You can click Cancel to close the Add Targets...
interface and retain the original list of selected systems.
• Select Remove Targets... and select the check box next to systems you wish to remove from
analysis. Select Apply. Selecting the check box in the top title row will select all systems for
removal. You can click Cancel to close the Remove Targets... interface and retain the original
list of selected systems.
Once you have finalized the systems to be analyzed, select Run Now to either run an analysis
immediately or to schedule an analysis.
NOTE: The Add Event Filter... selection provided by HP SIM is not a valid selection for HP-UX
Software Assistant.
Setting report options for SWA in HP SIM
Use the SWA Options page to select the analyzers, networking parameters, and ignore files for
this analysis. Catalog and networking parameters are under Advanced Options. By default, the
QPK, SEC, and PCW analyzers are selected; there is no custom networking information; and the
user ignore file $HOME/.swa/ignore is not selected and no other ignore files are specified. If
there is a networking proxy value defined in /etc/opt/swa/swa.conf, it will be reflected on
this page. Settings from previous runs are cached for the next session.
Generate report 29