Administrator's and User's Guide for SFM HP-UX 11i v1 April 2006

Installing the SFM Software
Verifying the Installation
Chapter 2 29
Step 2. Enter the following command at the HP-UX prompt:
# swjob
If the output contains no errors, the SFM software is installed properly.
Otherwise, you must install the SFM software again.
A sample output is shown in the following figure:
Step 3. For information about installation-related errors, enter the following
command at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/