Administrator's and User's Guide for SFM HP-UX 11i v1 April 2006

Installing the SFM Software
Removing the SFM Software
Chapter 236
Step 7. When the SFM software is removed, the Remove Window is displayed, as
shown in the following figure:
Step 8. To verify whether the SFM software is removed properly, enter the
following command at the HP-UX prompt:
# swlist | grep SysFaultMgmt
If the SFM software is removed properly, SysFaultMgmt and the version
number of the SFM software does not appear in the output. If the SFM
software is not removed properly, you must repeat the removal
procedure. For more information, see “Verifying Removal of the SFM
Software” on page 38.
Removing the Software Using the CLI
To remove the SFM software from your system, complete the following
steps:
Step 1. Log in to the system as a superuser.
Step 2. Enter the following command at the HP-UX command prompt: