Administrator's and User's Guide for SFM HP-UX 11i v1 April 2006

Installing the SFM Software
Verifying Removal of the SFM Software
Chapter 238
Verifying Removal of the SFM Software
This section describes how to use the TUI and the CLI to verify whether
the SFM software is removed successfully.
Verifying Removal Using the TUI
To verify whether the SFM software is removed successfully, complete
the following steps:
Step 1. Log in to the system as a superuser.
Step 2. Click Logfile in the Remove Window.
If there are no errors in the Logfile, the SFM software is removed
successfully. If the SFM software is not removed properly, you must
repeat the removal procedure. See “Removing the SFM Software” on
page 30 for instructions on how to remove the SFM software.
Step 3. For information about errors related to the removal of SFM, enter the
following command at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the Logfile.
Verifying Removal Using the CLI
To verify if the SFM software is removed successfully, complete the
following steps:
Step 1. Log in to the system as a superuser.
Step 2. Enter the following command at the HP-UX prompt:
# swjob
If the output contains no errors, the SFM software is removed
successfully. If the SFM software is not removed properly, you must
repeat the removal procedure. See “Removing the SFM Software” on
page 30 for instructions on how to remove the SFM software.
Step 3. For information about errors related to the removal of the SFM software,
enter the following command at the HP-UX prompt: