Administrator's and User's Guide for SFM HP-UX 11i v3 September 2012

5 Administering indications and instances using HP SMH

This chapter describes the SFM administration tasks that you can perform using HP SMH on a local

system.

This chapter addresses the following topics:

• “Viewing instances” (page 45)

• “Administering indications using Evweb” (page 50)

• “Viewing event subscriptions using Evweb” (page 57)

• “Viewing indications using Evweb” (page 60)

• “Tracing Evweb” (page 69)

• “EMT Overview” (page 72)

• “Querying the Common Error Repository” (page 72)

• “Administering Events in CER” (page 75)

• “Tracing EMT” (page 78)

Viewing instances

This section describes the tasks you must perform to view instances. This section discusses the

following topics:

• “Viewing information about processors” (page 45)

• “Viewing information about memory” (page 46)

• “Viewing information about System Summary” (page 47)

• “Viewing information about Cooling Devices” (page 47)

• “Viewing Power Supply instances” (page 47)

• “Viewing Temperature status and events” (page 47)

• “Viewing Voltage status and events” (page 47)

• “Viewing FRU information” (page 47)

• “Viewing information about Management Processor” (page 48)

• “Viewing information about Firmware information” (page 48)

• “Viewing information about Onboard Administrator” (page 48)

• “Viewing information about Complex-wide info” (page 48)

• “Viewing information about Cell Board” (page 48)

• “Viewing Partition information” (page 48)

• “Viewing information about Blade” (page 48)

• “Viewing information about Cell Blade” (page 49)

• “Viewing Health Test report of Memory” (page 49)

• “Viewing Health Test report of Processors” (page 49)

Viewing information about processors

To obtain information about processors, such as the processor type, architecture revision, and

processor speed, complete the following steps:

Viewing instances 45